measurement of surface tension of PLA for 3D printer using contact angle meter SL200K
                    
                    In this video, we show you surface tension of PLA for 3D printer. We 
used contact angle meter SL200K with high temperature chamber and high 
temperature syringe (max temp. about 450℃) to measure surface tension of
 melted PLA for 3D printer under temperature about 250-280℃ based on 
pendant drop method. And, we used ADSA-Realdrop method from CAST3.0 
disigned by USA KINO to calculate surface tension of melted PLA for 3D 
printer. We found out that it is hard to form a shape of pendant drop 
under suggested melted temperature (about 190-220℃), and shape of melted
 PLA is hard to be controlled to form a drop shape. So, measured value 
of melted PLA for 3D printer (about 36-42mN/m) is just a reference for 
you, and we suggest you measure SFE for PLA, and then check out if 
measured value used melted PLA way is suitable. Visit 
http://www.uskino.com to find more information about contact angle meter.